Harris QSEE6800 Plus H, Инструкция по установке и эксплуатации

Страница: 40 / 86

26 QSEE6800
+
H Installation and Operation Manual
Chapter 3: Card-Edge and Parameter Operation
Setting QSEE6800
+
Remote Control
Parameters
Table 3-2 lists all of the remote control parameters and options for the
QSEE6800
+
H. To access these parameters, you must use
+
Pilot Lite or
CCS control software such as Pilot or Navigator. See your software user
manual and
Chapter 4: “CCS Operation” on page 41 for information on
controlling the module.
All parameters clip unless otherwise indicated .
Legend
Bold option = Indicates that this is the default setting for the parameter.
[RO] = Indicates that parameters are read-only/feedback, and cannot be
used to select controls.
Table 3-2. Parameter Options—QSEE6800
+
H Modules—Remote Control Only
Parameter Name
1
Function Options
Network
IP Address Specifies the module’s IP address String
(Initial value:
192.168.100.252 )
Subnet Mask Specifies the module’s subnet mask String
(Initial value: 255.255.255.0 )
Gateway Specifies the module’s gateway
address String
(Initial value:
192.168.100.252 )
Multicast IP address Specifies the IP address from which
multicasts are broadcast String
(Initial value:
239.1.1.1 )
Multicast TTL Specifies the time-to-live of the
multicast range: 0 to 9 ( 3 )
Apply Changes Saves the Network settings to the
module
• Yes
•
No
Call Factory Default Restores the factory default
parameters and alarm settings for
the QSEE6800
+
H module and its
inputs
• Yes
• No
Soft Reboot Reboots the card remotely
• Reboot
•
----