Harris FR6822+, Инструкция по установке и эксплуатации

Страница: 45 / 128

31
Copyright © 2008-2011, Harris Corporation
4
FR6822
+
QXFE Configuration,
Monitoring, and Control
Overview
While a FR6822
+
and its installed modules can be controlled at the card edge as described
in Chapter 3, F Frame and Module Operation , there are many more control and
monitoring options with the addition of a 6800
+
ETH resource module. These are described
in the following sections:

Using CCS Software with QXFE on page 31

Using an HTTP Browser with QXFE on page 44

Control and Monitoring QXFE Using SNMP on page 60

Basic 6800+ETH Module Operation on page 69
If you will only be using one monitoring system for your 6800
+
devices (for example HTTP),
you can turn off notification methods for other communication protocols to reduce network
traffic. See
Using CCS Software with QXFE on page 31 for more information.
Note: Except where noted, the term 6800
+
ETH is used in this manual to refer to 6800
+
ETH
and 6800
+
ETHSNMP resource modules.
Using CCS Software with FR6822
+
QXFE
CCS configuration and control of FR6822
+
QXFE frames begins with the discovery process.
When you enter the IP address of the 6800
+
ETH module and run a discovery, all modules in
theFR6822
+
QXFE host frame are also discovered.
Note: 6800
+
ETH requires CCS software version 3.2.1 or higher for full functionality.
Once a 6800
+
ETH module is discovered in CCS Navigator, you can update its firmware and
change its IP address. You can adjust remote control parameters for 6800
+
ETH and the
modules in the host frame. If other modules in the 6800
+
ETH host frame are Q-SEE
compliant, you can view monitoring thumbnails for those modules.
See the following topics for more information:

Preparing for Configuration on page 32

Discovering Frames and Modules Using a CCS Application on page 32

Monitoring 6800+ Modules in CCS Navigator on page 33

Using Q-SEE Compliant Modules in QXFE Frames on page 33