Harris FR6822+, Инструкция по установке и эксплуатации

Страница: 16 / 128

Chapter 1
Introduction
2
Copyright © 2008-2011, Harris Corporation

Cools modules using a front-to-back airflow with alarm-monitored, low-noise fans
Control and Monitoring Using a 6800+ETH Module

Regulates and reports major frame operation and performance data to the control
system

Provides access to Ethernet for control and monitoring using CCS Navigator or a web
browser

Provides additional control via SNMP with the 6800
+
ETHSNMP option

Supports thumbnail transmission at a rate of three frames per second, for all modules
that support this feature within the frame, in CCS Navigator only
Power Supply

Houses two power supplies for full redundancy and load-sharing

Displays power and fault indicators on front panel

Includes captivated power cord(s) for AC power supplies to prevent accidental
unplugging (note: cords are not provided for the DC power supply configurations)

Provides choice of 6822
+
AC for AC power or 6800
+
48V for DC power; frame can
house two of either power supply or one of each

Includes a temperature-sensing submodule that provides alarm generation when the
frame is monitored by CCS Navigator
Component Descriptions
Components of the FR6822
+
frame are described in the following sections:

Front Panel on page 2

Rear Panel on page 3

Fan Assembly on page 4

Power Supply on page 5

6800
+
ETH Resource Module on page 5
Front Panel Figure 1-1 shows the front view of a FR6822
+
frame; and identifies the location of status
LEDs, cooling fans, and front panel release screws. Figure 1-2 shows the inside of the
frame with the front panel removed.