HARMSCO BC4 Series, Инструкция по установке и эксплуатации

Страница: 4 / 20

BC4, MANUAL
Page 4 of 20
INSTALLATION
The following diagrams show the Harmsco BC4 Housings with typical plumbing
hook-up requirements.
Note: Do not install the unit in direct sunlight.
Do not install near a heat source.
1. Install incoming water supply to 2” FNPT coupling marked "Inlet".
2. Install outlet line to 2" FNPT coupling marked "Outlet", use stainless steel fit-
ting.
3. Install valves in drain lines and connect to 1/2" FNPT couplings located at
the bottom center and side of housing. Use stainless steel fittings.
Note: It is recommended to plumb a by-pass line to
supply unfiltered water while servicing if necessary.
4. Mount and secure housing using the three slots at the bottom of the legs.
See Installation Diagrams.
5. A qualified technician should make all connections.
6. Ground the filter housing utilizing the grounding lug on the leg.
7. Make sure housing’s cartridges,
lid and clamp-band are properly
positioned, see the Filter Car-
tridge Maintenance Instructions.
8. Start the flow of water and allow
the housing to completely fill.
The Harmsco BC4 Water Filter is
now operational.
HARMSCO
®
Filtration Products
BC4 Series INSTALLATION AND OPERATION MANUAL
Grounding Lug,
Can be positioned
between any pair of
legs.