Harmony eXLhoist, Руководство пользователя

Страница: 140 / 228

Using The Wireless Remote Control System
140
EIO0000001505 12/2014
How to Modify the Configuration
Section 5.4
How to Modify the Configuration
How to Modify a Configuration
Configuration Modification
The following procedure describes how to modify the system configuration:
Result: The Remote Device goes to STOP mode ( see page 123 ) .
It is recommended to redo an Acceptance Test ( see page 75 ) .
Configuration File load With a ZART8L
After the modification of the configuration with the eXLhoist Configuration Software:
Result: The Remote Device goes to STOP mode ( see page 123 ) .
It is recommended to redo an Acceptance Test ( see page 75 ) .
Step Action
1 Connect the Remote Device to a PC ( see page 165 ) .
2 Start the eXLhoist Configuration Software ( see page 178 ) .
3 Create a project ( see page 179 ) .
4 Modify the configuration of the project ( see page 188 )
5 Select Communication
→
Store to Device .
6 Wait for the end of the Configuration File load in the Remote Device.
7 Disconnect the Remote Device to the PC.
8 Power ON the Base Station.
9 The Configuration File must be loaded from the Remote Device to the Base Station.
Refer to:

Configuration File load With a ZART8L ( see page 140 ) .

Configuration File load With a ZART•D ( see page 141 ) .
Step Action
1 Power ON the Remote Device.
2 The Configuration File is automatically loaded from the Remote Device to the Base Station.
During the load, the START LED and “2” LED are flashing
( see page 157 ) .
Wait for the end of the Configuration File load.