Harmonic PWRLink II 4800T Series, Руководство по эксплуатации продукта, Страница: 10 / 43

Installing the PWRLink II Transmitter
2–2 Copyright © 2002 Harmonic Inc.
Figure 2-1. HMC 4000 module carrier front and rear panel features
To install the transmitter module in the HMC 4000 carrier:
• Insert the transmitter into the carrier until it locks into position.
To remove the transmitter module from the HMC 4000 carrier:
• Press down the spring-loaded tab on the carrier, then pull out the module.
To install the HMC 4000 carrier in the HLP 4200 platform:
1. Lower the HLP 4200 platform’s control/display panel.
2. Slide the HMC 4000 carrier into any available slot in the platform until it is
properly seated.
3. Lock the carrier into position with the carrier locking screw, shown in
Figure 2-1.
The PWRLink II transmitter receives power from the HMC 4000 carrier.
The carrier is powered by the +24 VDC bus of the HLP 4200.
For additional information on the HLP 4200 platform, see the HLP 4200
Instruction Manual. For additional information on platform controllers and/or
power supply options, see the respective Harmonic manual for each
component
.
PL49CRR