Harmonic Electra9200, Руководство по установке

Страница: 45 / 115

Chapter 5 Maintenance and Troubleshooting Bezel
© 2015 Harmonic Inc. All rights reserved. 38 Electra 9200, Rev O
CAUTION: The front panel display on the encoder is susceptible to electrostatic discharge (ESD)
when the bezel is removed. Wear the appropriate ESD protection when the bezel is removed.
Removing and Replacing the Bezel
You do not need to turn off the encoder when removing and replacing the bezel.
To remove the bezel:
1. Locate the lever on the front of the bezel and push to the right to disengage the right side
of the bezel, as shown in step 1,
Figure 5–1 .
Figure 5–1: Removing the Bezel
2. Pull the right side of the bezel towards you, as shown in step 2,
Figure 5–1
.
3. Ease the the bezel away from the fan tray. The bezel is secured to the fan tray by a clip, as
shown in step 3,
Figure 5–1 .
4. Ease the left side of the bezel away from the unit, as shown in step 4,
Figure 5–1
.
3
Back Side of
Bezel
4
(RN-08)