6
| www.harmar.com | 800-833-0478
TEC0030 30NOV15 PN: 630-00002-01 REV B
Operating Your Lift
3.
Seat yourself securely before operating the
lift. Apply the wheelchair brakes.
4.
To operate, continuously press the hand
control switch on the side in which you wish
to travel. If you release the control switch the
lift will stop. Continue to press the switch or
button all the way to the landing. The lift will
gently stop at the appropriate, preset point.
5.
To safely exit the lift, make sure the ramp is
down in contact with the floor.
If you are operating the lift remotely on
behalf of another person, please ensure that
they are securely seated and their wheelchair
is stopped. Always keep the person in line of
sight before commencing movement.
OBSTRUCTIONS:
An orange light
and single beep indicate that the lift
has touched an obstruction and may
only be operated in the opposite
direction of the obstruction. Clear the
obstruction before proceeding.
If the light flashes orange and the lift
beeps intermittently, the lift has been
stopped away from the top or bottom
charging stations. Please move the lift
to either end of the rail to ensure the
batteries remain fully charged.
The LED indicator light will turn red if
there is a service issue. Turn the “ON/
OFF” switch to the “OFF” position (O)
and then back to the “ON” position
(I). The lights should sequence red-
orange-green. If the light does not
return to green, please call your
service representative.
HAND CRANK OPERATION
If your lift fails to operate and the operator does
not wish to dismount on the staircase, another
person may use the manual hand crank to lower (or
raise) the lift to a landing.
However, please follow the instructions on the
bottom safety flap of the lift and turn the lift off.
Insert the hand crank into the hole in the lower
safety flap until it engages the motor shaft, and
turn in the direction indicated.
(con't)
WARNING
Never attempt to operate the lift
while standing up. Always sit in the
center of the platform.
