Harmar Mobility AL600 Pioneer, Руководство пользователя

Страница: 7 / 20

AL600 / AL600HD:
Owner’s Manual
19MAR2021 | MKT-000174 REV A
7
OPERATION
AL600 / AL600HD: SECTION 3
SECTION 3
OPERATION
LOADING AND SECURING
YOUR MOBILITY DEVICE
Using your remote control, lower the lift platform
until it reaches the ground and becomes level.
See Figure 3-1.
LEDs
Down
Up
Power
Button
Figure 3-1
NOTE: Your lift is designed to draw power from the car
battery as needed and will operate while the vehicle is
off. However, it is recommended that the lift be operated
while the car is running for optimal performance.
1. Drive your mobility device onto the platform.
Determine the heaviest portion of the mobility
device. This is usually under the drive wheels,
motor(s), and batteries. Always drive onto the
platform with the heaviest portion closest to
the lifting tower. If loading a scooter and the
platform has the AL617 extension plate, drive
onto the platform so that the scooter’s front
wheels are resting on the extension plate,
and the rear wheels are on the main platform.
This allows the heaviest portion of the scooter
to be closest to the lifting tower. Set your
mobility device speed control to slow speed to
maneuver easily onto the platform.
See Figures 3-2.
SLOW
Scooter
extension
plate
Figure 3-2
The power button must be pressed to enable the hand
control to operate. At which time, the buttons will
light up and the front LED’s will act as a flashlight.
If no button is pressed after approximately two (2)
minutes, the hand control will turn off automatically.
Press the power button to turn back on.
NOTICE