5
7. The Rotation Limit Collars are attached to the Post with 1/4-20
bolts. If you need to adjust the height of the power frame, you
may change the vertical position of the rotation limit collars along
the post. To do so the post is equipped with a series of holes to
accept the bolt from the rotation limit collars. The close together
holes are for fine adjustments and the others are for larger
adjustments.
Caution:
Both rotation limit collars must be bolted to the post
for the lift to operate. Do not add any additional holes to the post
or modify any part of the lift.
8. Plug the AL065 Wiring Harness into the black plug on the
Vehicle Wiring Harness. Route the Al065 Wiring Harness along
the bottom of the Arm Assembly to the base of the Post. Secure
the wiring harness to the Arm Assembly using the adhesive black
plastic clips in the hardware pack. Position the female end of the
Al065 Wiring Harness where it can be easily accessed for
attaching the Hand Control. The user will need to attach and
remove the Hand Control each time they use the lift.
Caution:
Attach the female end of the Wiring Harness so that
it points down and will not collect water.
Caution:
Read the operation instructions before performing
Step 9.
AL065 Wiring Harness
Black Adhesive Clip
10. To move the Strap Roller, remove the Split Ring (like on a
key chain) from the Clevis Pin. Pull out the Clevis Pin and Strap
Roller and replace it in the desired hole location.
9. Plug the Hand Control into the AL065 Wiring Harness and into
the motor on the Power Frame. You are now ready to test lift a
chair. Lower the lift’s hook down and attach it the docking device
on your chair. (See your docking device’s instructions for correct
installation and operation.) Raise the chair and carefully swing it
into the vehicles rear door or trunk. If the chair will not fit through
the opening carefully swing it back out and return it to the ground.
You may need to adjust the location of the Arm Assembly (Figs.
1, 2, 3) or the location of the strap roller.
11. The lift may be left assembled during transport. To do so you
will need to secure the Power Frame so that it does not swing
while the vehicle is in motion. Lower the strap hook and attach it
to the oval shaped slot in the Arm Assembly. Tighten the strap
until it is snug but not overly tight. Push on the power frame and
verify that it can not hit the vehicle.
