Harman R11 Скачать руководство пользователя

Страница: 25 / 36

Harman Oakwood

Seasonal cleaning

At least once per year, the stove, venting connectors

and chimney should be thoroughly cleaned. If the areas are
found to have an excessive build up of ash or creosote, it is
recommended to increase the frequency of the cleaning. This
will extend the life of the appliance and its components. A

vacuum specifically designed for ash is preferred, however

a standard “Shop-Vac” with a HEPA filter may also work

just fine.

During cleaning, caution must be taken not to damage the

white / gray colored ceramic combustion package in the rear

of the firebox. When using a brush in the chimney or venting

connector, the by-pass damper should be placed in the open
position to help prevent ash, creosote or other debris from
falling down onto and around the combustion package. This
also protects the top of the combustion package from tool
or brush damage and diverts most of the removed materials

into the firebox for easy clean-up and removal. Once the

venting system has been cleaned, remove the first section

of connector pipe from the appliance flue collar. Carefully

vacuum the ash and debris from around the sides and top of
the combustion package.

The ramp brick must be removed to allow vacuum access

for cleaning the front portion of the combustion package.

Always use caution when refueling or when vacuuming

the firebox and combustion package. Some users have dam

aged their combustion package with vacuum cleaner tools,

and fire pokers.

the stove

surface

The stove’s exterior surface should be dusted periodi

cally with a soft cloth. For more thorough cleaning, wait
until the stove is cool before using a damp cloth to clean
any blemishes.

Controls

To avoid a rust build-up on the inner surfaces of the

controls, work the controls back and forth several times,
during the summer, or any prolonged period when you are
not using your stove.

the Fire Chamber

The inside of the fire chamber should be examined for

damage to the refractory lining material, grates, and casting.
If any bricks have been damaged, replace them with Harman
replacement parts.

Glass - Replacement

If the stove’s glass is cracked or broken, you must replace

it before operating your stove. Remove pieces carefully.
Replace glass only with Harman replacement glass; do not
use substitutes.

To replace the glass panel, you will need to remove the

door. To do this, open the door, lift it straight up and place
it on a soft surface, or door stand that is an optional feature
with the Oakwood.

Carefully remove damaged glass, gasket material, and

hold down clips (set aside).

Referring to the diagram, note how the various compo-

nents of the door system fit together. Lay the load door face

down on the soft surface, and install the self adhesive 1/4"

gasket material around the front face of the glass. Note: this
glass has a special IR coating on one side. This coating must
be to the

outside

of the stove. The coated side has a label on

it. The coated side will also show a resistance reading.

Set the glass panel and gasket gently onto the door. In-

stall the hold down clips and tighten with bolts as shown.
Reinstall door on stove.

Glass - Cleaning

Occasionally, it will be necessary to clean accumulated

ash from the glass surface; allowing this ash to remain on
the glass for long periods can result in “etching” due to the
acidity of the ash. The creosote which accumulates on the

glass should burn off during your hot fires.

Never clean the glass while it is hot, and do

not

use

abrasive substances. Wash the surface with cool water, and
rinse thoroughly. You may wish to use a non-abrasive cleaner

specifically designed for use on stove glass. In any case, dry

thoroughly before relighting your stove.

MaIntenanCe