15
P 6 1 A P ellet S tove
3 -9 0 -0 5 8 2 2 R 2 8 _ 0 8 /1 3
AUTOMATIC IG NITION/ OPER ATION
The P 1A is a fully automatic stove that features two
operating modes
Stove Temperature Mode
and
R oom
Temperature Mode
. In Stove Temperature ode, you select
a burn rate and the stove will remain at the same burn rate
regardless of the room temperature.
In the Room Temperature ode the stove constantly monitors
the temperature in the room and ad usts the size of the fire
and the heat output of the stove so that the room is kept at
a constant temperature. Room mode, in the AUTO position,
has the added advantage of turning the stove off if no heat
is required and turning the stove on again when the room
temperature drops below your desired room temperature.
R oom Temperature Mode
ost consumers use the stove in the Room Temperature
ode because it is the easiest and most efficient method
of keeping the room at a given temperature. In the Room
Temperature ode, the Room Sensing Probe constantly
monitors room temperature. As the weather changes outside
and your home needs varying amounts of heat to be at a
desired temperature, the stove will automatically increase fire
size and heat output so that a constant even temperature is
maintained. If the weather warms up and no heat is required,
the stove will gradually shut down. When the house cools
down, the stove will automatically bring the room temperature
to the precise temperature you desire.
In the Room Temperature ode you can select either
Auto
or Manual modes
for the
igniter,
using the igniter toggle
switch. When the toggle switch is in the Auto position, the
igniter, located inside the burn pot, is ready to automatically
light the fire when required. When the toggle switch set to the
anual position the stove can be lit manually with either a gel
or a wax type fire starter. (see lighting instructions on page
1 .) With the igniter toggle switch set in the anual position
the stove will automatically ad ust heat output, but the stove
will not automatically shut down if no heat is required. Instead
it will go to its lowest setting and remain there. The anual
position on the igniter toggle switch lets you light the stove
manually, should the igniter fail for any reason. Secondly if
you are using the Harman battery back up system, the anual
setting will prevent the stove from turning off and on during
a power failure, which would drain the back up battery, and
possibly cause damage to the back-up or the stove.
In the Room Temperature ode, the distribution blower speed
can be increased or decreased by ad usting the Room Temp
Off Stove Temp dial between L and H. As output of the stove
increases, the speed of the blower will increase automatically
to insure that more heat is transferred out into the room. The
distribution blower will shut off as the room reaches the set
temperature, this will prevent overheating of the room.
R oom Temperature Mode:
This setting, see above, will produce
a room temperature of 70 degrees with the distribution blower at
medium speed.
R oom Temperature Mode
CAUTION:
O
NOT
CONNECT TO ANY AIR ISTRIBUTION UCT
OR SYSTE .
O
NOT
BURN GARBAGE OR LA
ABLE LUI S
SUCH AS GASOLINE, NAPTHA, OR ENGINE OIL.
HOT WHILE IN OPERATION.
EEP CHIL REN,
CLOTHING, AN URNITURE AWAY. CONTACT AY
CAUSE S IN BURNS.
EEP IREBO AN ASH RE O AL OORS CLOSE
URING OPERATION.
AINTAIN SEALS IN GOO
CON ITION.
