Physical installation
15
Installing with other Martin® creative video products
VDO Dotron dots can be fastened to other Martin® creative video products using coupler brackets available
from Martin® (see “Accessories” on page 35).
Fastening to the end of a VDO Sceptron or VDO Fatron
To fasten a VDO Dotron to the end of a VDO Sceptron or VDO Fatron fixture:
1. See Figure 5. Pass four grade 8.8 (or equivalent strength) M4 x 8 mm countersunk screws through the
four holes
A
in a Dotron to Sceptron End Coupler and fasten them into the back of the Dotron. Use a
torque driver to tighten to 2.5 Nm.
2. Slide the two nuts
B
into the channel in the back of a Martin® Sceptron or Fatron fixture and tighten the
two Allen bolts
C
into the nuts
B
to fasten the coupler to the fixture.
3. Attach a safety cable or similar secondary attachment to attachment point
D
and to a secure anchoring
point so that the safety cable will catch the VDO Dotron if the primary attachments fail.
4. Connect the dot’s input connector to the output connector of the previous device on the link, either
directly or inserting a relay cable. Make sure that all connectors are correctly fastened together with
locking rings twisted to ensure a seal.
5. Check that the dot is held securely before you leave it.
Fastening between two VDO Sceptron or VDO Fatron fixtures
To fasten a VDO Dotron between the ends of two VDO Sceptron or VDO Fatron fixtures:
1. See Figure 6. Pass four grade 8.8 (or equivalent strength) M4 x 8 mm countersunk screws through the
four holes
A
in a Dotron to Sceptron Pivot Coupler and fasten them into the back of the Dotron. Use a
torque driver to tighten to 2.5 Nm.
2. Slide the nuts
B
into the channel in the back of a Martin® Sceptron or Fatron fixture and tighten the two
Allen bolts
C
into the nuts
B
to fasten the coupler to the fixture.
3. Attach a safety cable or similar secondary attachment to attachment point
C
and to a secure anchoring
point so that the safety cable will catch the VDO Dotron if the primary attachments fail.
4. Connect the dot’s input connector to the output connector of the previous device on the link, either
directly or inserting a relay cable. Make sure that all connectors are correctly fastened together with
locking rings twisted to ensure a seal.
5. Check that the dot is held securely before you leave it.
Figure 5: VDO Dotron to Sceptron End Coupler
VDO Dotron to Sceptron End Coupler, P/N 91616071
D
A
B
C
Figure 6: VDO Dotron to Sceptron Pivot Coupler
VDO Dotron to Sceptron Pivot Coupler, P/N 91611793
C
A
B
B
www.audiovias.com
Содержание Martin VDO Dotron
Страница 1: ...VDO Dotron User Manual www audiovias com...
Страница 38: ...www audiovias com...
Страница 39: ...www audiovias com...
Страница 40: ...www martin com Olof Palmes All 18 8200 Aarhus N Denmark Tel 45 8740 0000 Fax 45 8740 0010 www audiovias com...
