Harman Martin MAC Ultra Wash, Инструкция по безопасности и установке

Страница: 13 / 28

Data links
13
Data links
Important! Shut down power to the fixture before connecting to or disconnecting from data.
The MAC Ultra Wash has two pairs of connectors for control data In/Out:
• one pair of XLR sockets ( A in Figure 8), and
• one pair of etherCON sockets ( B in Figure 8).
Only use one socket type –
either
XLR
or
etherCON – at any one time.
Data via DMX cable
The MAC Ultra Wash has 5-pin locking XLR sockets (see A in Figure 8) for DMX and RDM input and output
via DMX cable. The default pin-out on both sockets is:
• pin 1 to shield
• pin 2 to data 1 cold (-)
• pin 3 to data 1 hot (+).
Pins 4 and 5 are not used by the fixture but are bridged between input and output sockets. These pins can
therefore be used as a pass-through connection for an additional data signal if required.
Tips for reliable data transmission via DMX cable
• Use shielded twisted-pair high-quality DMX cable.
• 24 AWG cable is suitable for runs up to 300 meters (1000 ft). Heavier gauge cable and/or an amplifier is
recommended for longer runs.
• Do not use microphone cable, as standard microphone cable does not have the correct impedance and
cannot transmit control data reliably over long runs.
• To split the data link into branches, use an optically isolated splitter-amplifier.
• Do not overload the DMX data link. You can connect up to a maximum of 32 devices on a serial DMX link.
• Install a DMX termination plug on the last fixture on the link.
Connecting to data via DMX cable
To connect the MAC Ultra Wash to DMX and/or RDM data carried over DMX cable:
1. Shut down power to the fixture.
2. Connect the DMX data output from the controller to the MAC Ultra Wash’s data input (male XLR) socket
using good-quality DMX cable.
3. Run DMX cable from the MAC Ultra Wash’s data output (female XLR) socket to the data input of the next
fixture and continue until the link is complete.
Figure 8: Data connections
A
B