6
3-90-70745R16_08/13
Align the holes in the wings with the holes in the insert
and begin inserting the screws. Note that there is a right
wing and a left wing.
After the side wings are installed, the top wing can be
installed. The tabs on the top wing slide behind the
bottom wing and the tabs on the bottom wing slide behind
the tabs on the top wing.
One step remains before you are ready to slide the insert
in its final position in the fireplace. The area between the
wing and the fireplace front must be packed with fiberglass
insulation to provide a good air seal at the face of the
fireplace. This step is very important because a poor seal
at this point will cause a loss of draft and could cause poor
performance of the insert.
With the insulation in place, go ahead and slide the insert
tightly back into the fireplace.
The floor of the insert has adjusting bolts. The adjusting
bolts can be reached through the ash door. The bolts can
be used to adjust the level of the stove by turning clockwise
to raise the corner of the stove, and counter-clockwise to
lower the corner of the stove.
The blowers are already installed in the side wings, but you'll
need to complete the wiring.First, determine which side the
power cord needs to be routed from. Follow the wiring diagram
to attach the power cord. Then, link the two blowers together
with the high temperature wire that is looped through the back
of the insert body.
Place the blower cover retainer in the blower box as shown
below. Keep the retainer centered to allow for easier hole
location.
Next, using the corner clips provided in the hardware package,
install the brass trim onto the lid.Place the lid onto the blower
box and slip the flat-head screw downward through the lid
and tighten it into the retainer. (Repeat for both sides)
Next, slide the insert into the fireplace making sure that the
front tab of the flue adapter is resting on top of the insert.
This tab may now be used as a guide to help locate the
connector base on the flue opening of the insert. Begin
sliding the insert in place while guiding the connector base
into its proper location. With the adapter close to centered
on the top of the insert body, the hooks at the back side of
the adapter should pull the adapter into position as the insert
slides back.
If needed, you can reach up
through the hole in the baffle
to guide the flue adapter
into place.
Open the loading door and
look into the rear of the
firebox. Notice the hole left
in the baffle of the insert.
This hole is to allow you
to reach into the flue and
grab the cross-member in
the flue adapter.
ASSEmblY & INSTAllATION
looking through front door
Figure C
Once the flue adapter is in place on the insert, install one
button head screw through the wing mounting flange and
into the hole on the flue adapter guide handle. Tighten the
screw to secure the flue adapter during the completion of
the installation.
After final adjustment, place the flue plate behind the baffle
and cover the access hole.
With the insert sitting on the hearth, installation of the insert
wings is accomplished by first removing the screws that are
around the perimeter of the insert front. Once these screws
are removed, the side wing sections should be installed.
