TRIM
FOLD
TRIM
Cycle 1
150 lpi
6-3-08 SoundStick_II_Set-Up_Guide.qxd
K
R
L
Step 5.
Plug power cord
into power adapter.
Step 6.
Plug power
adapter into subwoofer.
Step 7.
Plug power cord
into wall receptacle.
Step 8.
Push power
ON/OFF button. Unit is
on when LED is lit.
Step 9.
Adjust volume
level by to or –
button. Touching both the
+ and – buttons mutes the
audio. When muted,
touching either button
unmutes the audio.
Symptom
No sound from subwoofer,
only satellites.
No sound from satellites,
only subwoofer.
High frequencies sound dull.
Possible problem
Subwoofer volume control set
at minimum.
Satellites not connected
to subwoofer.
Satellites not positioned properly.
Solution
Rotate subwoofer volume control clockwise until relative volume level
is appropriate.
Check connection of satellites to subwoofer.
Position and tilt (angle) loudspeakers toward listener. The sound from the
satellites is very directional due to the 4-element linear array design
.
www.harmankardon.com
This product is intended to be supplied by a listed direct plug-in power unit marked “Class 2” and output rated 16V DC minimum 1.5 A.
Symptom
No sound from SoundSticks II
speaker system.
Possible problem
No power to subwoofer.
Power adapter plug not inserted
correctly.
No volume or low volume.
Solution
Ensure power supply is connected to live power source and is properly
connected to subwoofer. Please note: When subwoofer is powered,
a power LED should light.
Place plug with arrow symbol facing UP into the subwoofer.
Touch the volume “Up” (+) pad on the volume control satellite to
unmute and/or increase the system volume level.
Note: Touching the volume “Down” (–) pad lowers the system volume.
Touching both (+) and (–) volume control pads at the same time will
mute the system.
Troubleshooting
Specifications*
System
Frequency range: 44Hz – 20kHz
Power consumption: 4W idle, 65W maximum
Subwoofer
Transducer (1): 6" woofer
Amplifier output power: 20W RMS
Dimensions (W x H): 9-3/16" x 10-3/16"
(232mm x 258mm)
Weight: 4 lb (2.2kg)
Satellite
Transducers (4): 1" full-range per channel
Amplifier output power: 10W RMS per channel
Dimensions (W x H): 2" x 10" (51mm x 254mm)
Weight: 1.5 lb (0.7kg)
SoundSticks
®
II
easy setup guide
*These specifications are subject to change without notice.
Step 1
. Place individ-
ual SoundSticks
®
II
(satellites) beside
monitor/computer.
Step 2.
Place sub-
woofer as desired,
but placement under
your desk will provide
optimal performance.
Step 3.
Connect satel-
lites to subwoofer.
Step 4.
Insert
SoundSticks II
input cable into the
computer or other
audio device.
R
L
