Harman JBL STUDIO 2 6IW, Инструкция по эксплуатации

Страница: 5 / 12

5
JBL Studio 2 In-Wall Architectural Loudspeaker
Instruction Manual
English
MOUNTING THE SPEAKERS
For New Construction
If you wish to pre-install a rough-in frame for the speakers before
the drywall is installed in new construction, you will need to purchase
the correct rough-in frame kit for your loudspeaker model from your
authorized JBL dealer. Detailed mounting instructions are supplied with
the rough-in kit. After the drywall is installed, follow the installation
instructions in For Existing Construction, below.
For Existing Construction
Note: The installation procedure is the same for all models covered by
this manual.
1. Ensure that the drywall, plywood or other wall material is 1/2" – 2"
(13mm – 51mm) thick and capable of withstanding the weight of the
speaker being installed.
Make sure to allow at least 1" (25.4mm) between the edge of the
supplied installation template and any rafters or other obstructions behind
the wall, so the speaker’s locking mechanism will have room to engage
fully. Perform an obstruction survey to be sure that there are no studs,
lengths of conduit, pipes, heating ducts or air returns in the wall cavity
that will interfere with the speaker.
1 "
(25.4mm)
1 "
(25.4mm)
1 "
(25.4mm)
Mounting
Opening
2. Determine the correct speaker location and use the template included
with the speaker to mark the wall material.
3. Cut the drywall along the mark you made in Step 2 to create the
mounting opening.
4. Connect the speaker to the amplifier as explained in Connecting to the
Amplifier, on page 4.
Speaker Clamps in
Ready-to-Mount Position
5. Make sure all four speaker clamps are in their “ready-to-mount”
position.
Speaker Clamps in Ready-to-Mount Position