TECH TIPS
Troubleshooting tips and solutions to common service problems
For models: BU80/HTS-10
TIP# INFTT2000-01
Complaint:
How do you replace or service any of the front panel components on the Subwoofer faceplate for model
BU80/HTS-10.
Probable Cause:
The High level Input terminals, potentiometers and RCA jack are behind a sealed cover to protect the air-tight
integrity of the cabinet enclosure.
Solution:
1)
Unplug all external cables from the subwoofer; place the cabinet on a padded surface.
2)
Remove any subwoofer grille; remove the woofer from the cabinet. Detach the two connections from the
woofer terminals.
3)
Remove all Phillips screws holding the amplifier to the cabinet; remove the amplifier.
4)
Remove all knobs, nuts, and Philips screws from the outer control section of the amplifier faceplate.
5)
Locate the sealed cover on the inside of the amplifier faceplate (see illustration); the bead of adherent must be
broken to remove the main PCB with front panel components from the plastic faceplate. This is most easily
accomplished by CAREFULLY using a box cutter, exacto knife, or similar sharp instrument. First scrape all
excess material from the three surfaces; then force the blade into the groove between the rear cover and the
faceplate. DO NOT attempt to remove the rear cover from the main PCB.
6)
When enough material is removed, the main PCB with cover should pull away from the faceplate, exposing
the components.
7)
After servicing a bead of silicon seal or similar adherent must be applied to all surfaces where it was removed.
Reassemble the rest of the components in reverse order.
1 7
Amplifier/Subwoofer
BU-80/HTS-10
Содержание Infinity BU-80
Страница 30: ...30 HTS 10 REV C Power Amp Module PCB...
Страница 31: ...31 HTS 10 REV C CIRCUIT BOARD cont...
Страница 32: ...32 HTS 10 REV C CIRCUIT BOARD cont...
