Harman AMX N2400 Series, Инструкция по эксплуатации, Страница: 29 / 80

Encoder Configuration Options
N2412A/N2422A User Manual
29
TABLE 2
Settings Page: Advanced Settings (Cont.)
Option Description Notes
IR Repeat Holdoff Set the repeat delay between IR commands. The default
setting is 90 ms.
This is the amount of time before a new command is
sent. For example, when pressing and holding the
volume button on a remote control, this is how long
until the command is repeated.
IR Compatibility
Mode
Enable to set the IR compatibility mode commands. The default mode is disabled
Enable SNMP Enable to allow the device to handle Simple Network
Management Protocol (SNMP) queries.
Will need to provide the MIB file to the IT
department for use.
Relaxed Analog Input
Timing
Enable to allow small variances in the analog input (to
avoid video interruption).
Interleaved Multicast
Streams
Enables a multicast format which interleaves video and
audio streams.
In order for N-Series devices to communicate with
each other, their multicast settings must be
compatible.
Low Power Mode Enable to enable low power mode and disable all video
and audio.
When enabled, the unit draws less power and
produces less heat. It also comes back up much
quicker than a full power down. Must be disabled for
the unit to work again.
RS232 Settings
The section of the Settings page shown in Figure 23 is displayed when you click the RS232 Settings link. Options are described in
Table 3 .
FIG. 23 RS232 Settings
TABLE 3
Settings Page: RS232 Settings
Option Description
RS232 Baud Rate Select the appropriate baud rate for the RS232 serial interface. Default is 9600.
RS232 Data Bits Select the appropriate data bit count for the RS232 serial interface. Default is 8.
RS232 Parity Select the appropriate parity for the RS232 serial interface. Default is no parity ( none ).
RS232 Stop Bits Select the appropriate number of stop bits for the RS232 serial interface. Default is 1.