HARDWARE MANUAL – DX-TX-DWP-4K60 | 11
b)
Endpoint Mode (Switcher)
The primary function of the Transmitters is to work with compatible DXLink equipment as an endpoint
solution for transmission of HDMI over twisted pair cable.
1.
Connect one or more transmitters to the 4K60 DXLink input board of the DGX or the DXLink input
ports of the DVX-4K switcher and connect one or more receivers to the 4K60 DXLink output board
of the DGX or the DXLink output ports of DVX-4K switcher.
2.
Connect an HDMI source (such as PC) to the HDMI IN port of the transmitter with a high-quality
HDMI cable.
3.
Connect HDMI displays (such as TVs or projectors) to HDMI OUT ports of the receivers.
Applying Power
A desktop power supply is provided with each module. Automatic power supply to DXLink twisted pair
transmitter and receiver units are as follows:
Over local power by connecting the supplied desktop power supply to the 12V input.
Over the DXLink connection from a powered DXLink port on a DGX or DVX.
NOTE:
Local power takes precedence over DXLink power.
Power Budget
For TXs and/or RXs connected to an Enova DGX, use the Enova DGX Configuration Tool
(www.amx.com/enova) to determine power requirements of a configuration and if any DXLink TXs or RXs
should use local power.
IMPORTANT:
If a desktop power supply is used to power the unit, it must be the one provided, which must
not be altered in any way. AMX does not support the use of any other power supplies or PoE injectors as
they may potentially damage the DXLink equipment.
LED Status Indicators:
INDICATOR LED
NORMAL POWER UP
INDICATES
PWR
Green
The transmitter is powered on.
HDMI
Green or Off
Green: The HDMI signal is input.
Off: No HDMI signal input.
LINK
Green or Off
Green: DXLink signal is normal.
Off: No DXLink signal or link error.
