
Installation and Connection
44
AMM 10
The passive line output module
LINE OUT (PASSIVE)
is connected to the
MASTER CONTROL
module. It can only be used once in the system.
The
LINE OUT (PASSIVE)
module takes the electrically balanced output signal and uses it to
drive power amplifiers, mixing desks or similar equipment. The volume and tone are controlled
by the MASTER CONTROL. The level also depends on the setting of the input module that is
used.
Figure 14: Connecting XLR-OUT to MASTER CONTROL
The terminals of the LINE OUT module and the MASTER CONTROL module are coded so that
the two channels, left and right, cannot be confused.
ATTENTION
RISK OF INJURY!
The
PSU 10
power supply unit must be connected last.
This module may only be installed by qualified technicians, observing relevant technical
regulations and VDE directives.
Connection of the protective earth (PE) conductor is obligatory.
The power supply connector is mechanically coded and can only be connected to the socket
of the MASTER CONTROL. Because of the cable, the power supply unit must be mounted
directly adjacent to the MASTER CONTROL.
Figure 15: Connecting the power supply to MASTER
CONTROL
Connecting XLR OUT PAS.
Connecting the power supply
All manuals and user guides at all-guides.com