Harman® • Accentra52i-TC Owner’s Manual_R3 • 2017 -___ • 09/17
4
3-90-00584c
1
Product Specific and Important Safety Information
A. Appliance Certification
NOTE:
This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E 1509-12, ULC-S628-93
& (UM) 84-HUD
T H E S T R U C T U R A L I N T E G R I T Y O F T H E
MANUFACTURED HOME FLOOR, WALL, AND CEILING/
ROOF MUST BE MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
The
Accentra52i-TC Pellet Insert is certified
to comply with 2020 EPA particulate emission
standards.
MODEL:
Accentra52i-TC Pellet Insert
LABORATORY:
OMNI Test Laboratories, Inc
REPORT NO.
0135PN031E
TYPE:
Pellet Fueled Insert/Supplementary
For Residential Use
STANDARD(s):
ASTM E 2779-10, ASTM E 2515-11,
ASTM E 1509-12, ULC-S628-93
ELECTRICAL
RATING:
120 VAC, 60 Hz, Start 3.5 Amps, Run
2.5 Amps
GLASS
SPECIFICATION:
5mm mirrored ceramic glass
B. Mobile Home Approved
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling, and
walls must be maintained. The appliance must be properly
grounded to the frame of the mobile home and use only listed
pellet vent, Class “PL” connector pipe.
A Harman® Outside Air Kit must be installed in a mobile
home installation.
WARNING
!
Risk of Fire!
Hearth & Home Technologies disclaims any
responsibility for, and the warranty and agency listing will
be voided by the below actions.
C. BTU & Efficiency Specifications
EPA Certification Number:
84-17
EPA Certified Emissions:
1.1 g/hr
*LHV Tested Efficiency:
81.3%
**HHV Tested Efficiency:
76.1%
***EPA BTU Output:
7,400 - 39,700
****BTU Input
11,200 - 50,300
Vent Size:
4 Inch
Hopper Capacity:
64.5 lbs
Fuel
Wood Pellet
NOTE:
Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
* Weighted average LHV efficiency using data collected
during EPA emissions test.
**Weighted average HHV efficiency using data collected
during EPA emissions test.
***A range of BTU outputs based on EPA Default Efficiency
and the burn rates from the low and high EPA tests.
****Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU’s which is the average BTU’s from
a pound of pellets.
This wood heater has a manufacturer-set minimum low burn
rate that must not be altered. It is against federal regulations
to alter this setting or otherwise operate this wood heater
in a manner inconsistent with operating instructions in this
manual.
This wood heater needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this wood heater in a manner inconsistent with operating
instructions in this manual.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by Hearth & Home
Technologies
• Operate the appliance without fully assembling all
components
• Overfire
• Install any component not approved by Hearth &
Home Technologies
• Install parts or components not Listed or approved.
• Disable safety switches
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
Harman
®
is a registered trademark of Hearth & Home
Technologies.
This wood heater needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this wood heater in a manner inconsistent with operating
instructions in this manual.
CAUTION
!