Harman® • Absolute43 Owner’s Manual_R2 • 2015 -___ • 03/15
4
3-90-777000c
1
Product Specific and Important Safety Information
A. Appliance Certification / Specifications
C. BTU & Efficiency Specifications
The Absolute43
is EPA certified to comply with July 1990
particulate emission standards.
B. Mobile Home Approval
This appliance is approved for mobile and manufactured
home installations when not installed in a sleeping room and
when an outside combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling, and
walls must be maintained. The appliance must be properly
grounded to the frame of the mobile home and use only listed
pellet vent, Class “PL” or “L” connector pipe.
A Harman
®
Outside Air Kit must be installed in a mobile home
installation.
NOTE:
This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E 1509-04, ULC-S627-00, (UM) 84-HUD
MODEL:
Absolute43 Pellet Stove
LABORATORY:
OMNI Test Laboratories, Inc
REPORT NO.
135-S-32-2
TYPE:
Pellet Fueled/Supplementary For
Residential Use
STANDARD(s):
ASTM E 1509-12, ULC-S627-00
ELECTRICAL
RATING:
115 VAC, 60 Hz, Start 4.0 Amps, Run
3.0 Amps
GLASS
SPECIFICATION:
5mm mirrored ceramic glass
EPA Certification Number:
967-14
EPA Certified Emissions:
1.8 g/hr
*EPA Default Efficiency:
78%
**Actual Tested Efficiency:
69.3%
***EPA BTU Output:
33,900
****BTU Input
43,000
Vent Size:
3 Inch
Hopper Capacity:
52 lbs
Fuel
Wood Pellet, 50/50
Pellet/Corn Mixture
NOTE:
Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
*An efficiency based on EPA historical data of 78%
**Actual tested efficiency and data collected during EPA
emissions test
***A range of BTU outputs based on EPA default efficiency
and the burn rates from the low and high EPA tests
****Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU’s which is the average BTU’s from
a pound of pellets.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by Hearth & Home
Technologies
• Operate the appliance without fully assembling all
components
• Overfire
• Install any component not approved by Hearth &
Home Technologies
• Install parts or components not Listed or approved.
• Disable safety switches
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
Harman
®
is a registered trademark of Hearth & Home
Technologies.
T H E S T R U C T U R A L I N T E G R I T Y O F T H E
MANUFACTURED HOME FLOOR, wALL, AND
CEILING/ROOF MUST BE MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
WARNING
!
WARNING
!
Risk of Fire!
Hearth & Home Technologies disclaims any
responsibility for, and the warranty and agency listing will
be voided by the below actions.
