Harman Kardon OMNI 10+, Руководство пользователя

Страница: 17 / 32

16
WPS-PIN
To connect your speaker via WPS-PIN mode:
1. Use a web browser to navigate to your Wi-Fi router or access point’s setup page.
2. Press the WPS button on the bottom of your Omni 10+ or Omni 20+ for 5 seconds.
3. Enter 87654325 into the WPS-PIN section of your router or access point’s setup page.
4. The Link button on the top of the speaker will begin to quickly flash for up to one minute.
When the LED stops flashing and turns solid white, your speaker is connected.
Note:
This will connect your speaker to the network. After this is complete, you must open the
Harman Kardon Controller app and set up a new room for this speaker.
Ethernet
Although Omni 10+ and Omni 20+ are Wi-Fi enabled speakers, Ethernet offers
the fastest, most stable connection. If you are placing a speaker in a location
where connecting it to the network via Ethernet is convenient, just connect a
standard Ethernet cable to the Ethernet connector on the bottom of the speaker.
No additional Wi-Fi setup is required.
Ethernet can also be used to connect speakers which are out of Wi-Fi range.
Note:
This will connect your speaker to the network. After this is complete, you must open the
Harman Kardon Controller app and set up a new room for this speaker.
Stereo Pair Setup
When setting up a stereo pair,
speaker placement is important.
You should place both speakers
in a semicircle with your listening
position at its center. Angle each
speaker so it directly faces the
listener. Place the speakers at the
same height, preferably at about
the same height as the listener’s
ears.
After placing the speakers and
connecting them to Wi-Fi (see
Connecting Your Speaker to Wi-Fi
on page 13), the Controller app will
SP
E
A
K
ER
SE
T
U
P
Left Right