Harman Kardon HKTS 60BQ, Руководство пользователя

Страница: 6 / 14

6
5. If you’re not running the speaker wire through the wall, insert it through the
wall portion of the bracket, as shown in the illustration.
6. Pass the speaker wire through the speaker portion of the wall-mount bracket,
as shown in the illustration.
Bring Wire In
through Here
Bring Wire out
through Here
7. If you have not already removed the speaker’s base, do so by pulling it straight
off the speaker, as shown in the illustration. Applying even pressure to both
sides of the base will allow it to slide off smoothly.
CAUTION: Before making speaker connections, be sure that your receiver or
amplifier is turned OFF and its AC cord is unplugged from the AC outlet.
Apply Pressure Evenly
to Both Sides of Base
Lift Base Straight
off Speaker
8. Connect the speaker wire to the speaker terminals as shown in
the illustration:
a) Press down on the top of the terminal to open the connection hole.
b) Insert the wire’s bare end all the way into the hole.
c) Release the terminal to secure the wire.
Insert the conductor with the colored band into the speaker’s red ( + ) terminal,
and insert the other conductor into the speaker’s black ( – ) terminal.
IMPORTANT: Make sure the ( + ) and ( – ) bare wires do not touch each other or
the other terminal. Touching wires can cause a short circuit that can damage
your receiver or amplifier.
+
–
A. Push Down on Cap
to Open Hole B. Insert Bare Wire
into Open Hole C. Release Cap
to Secure Wire
10. Slide the speaker onto the bracket’s wall section, as shown in the illustration. Pull
any slack speaker wire back through the bracket’s wall section.
11. Fit the metal stop plate into the recess on the bottom of the bracket with the pad
facing the bracket, and fasten it to the bracket using two of the supplied screws.
Fastening it will prevent the speaker from detaching from the bracket and will hold
the speaker’s position as you rotate it.
Slide Speaker
onto Wall-Mount
Bracket
Stop Plate
Supplied Screws
9. Slide the speaker portion of the wall-mount bracket onto the speaker as shown in the
illustration. Fit the grooves on the bracket onto the rails in the speaker, and apply
even pressure on both sides of the bracket so it slides straight onto the speaker.
s0USHTHEBRACKETALLTHEWAYONTOTHESPEAKERUNTILITSNAPSINTOPLACE
s0ULLANYSLACKSPEAKERWIREBACKTHROUGHTHEBRACKETASYOUSLIDETHE
bracket onto the speaker.
Fit Bracket Grooves
onto Speaker Rails
Push Down Evenly on Both Sides of Bracket
NOTE: If you’re running the speaker wire through the wall, you can bring it out
directly behind the bracket location and insert it through the bottom opening in
the wall portion of the bracket, as shown in the illustration. Running the wire in
this way will keep the wire completely hidden from view once the installation is
complete.
Insert Wire into
Bottom Opening
Bring Wire out
through Here
Speaker Placement
HKTS 60BQ