Harman Kardon HK 3370, Руководство по обслуживанию

Страница: 9 / 123

9 REAR PANEL CONNECTIONS
Rear Panel Connections
¡
AM Antenna:
Connect the AM loop
antenna supplied with the receiver to these
terminals. If an external AM antenna is used,
make connections to the
AM and GND
terminals in accordance with the instructions
supplied with the antenna.
™
FM Antenna: Connect an indoor or
external FM antenna to this terminal.
£
Phono Ground: Connect the ground
wire from a turntable to this terminal to reduce
system hum.
¢
Remote IR In: If the HK 3370’s front
panel IR sensor is blocked due to cabinet doors
or other obstructions, an external IR sensor may
be used. Connect the output of the sensor to this
jack.
∞
Remote IR Out: This connection permits
the IR sensor in the receiver to serve other
remote controlled devices. Connect this jack to
the “IR IN” jack on Harman Kardon or other
compatible equipment.
§
Phono Inputs:
Connect the outputs of
your turntable or tone arm to these jacks. Note
that only Moving Magnet (MM) type cartridges
may be used.
¶
CD Inputs: Connect these jacks to the
output of a compact disc player or CD changer.
•
Aux Inputs: Connect these jacks to the
line-level output of any audio device such as a
TV, cable converter or portable audio player.
ª
Tape Monitor Play/In: Connect these
jacks to the Play/Out jacks of an audio recorder.
‚
Tape Monitor Record/Out: Connect
these jacks to the Rec/In jacks of an audio
recorder.
NOTE: When these jacks are connected to a
three-head recorder or another device with off-
head playback, it will be possible to monitor
the source being recorded.
⁄
Tape 2 Play/In: Connect these jacks to
the PLAY/OUT jacks of a second audio recorder.
¤
Tape 2 Record/Out: Connect these
jacks to the Rec/In jacks of a second audio
recorder.
‹
Main In: These jacks are the input to the
HK 3370’s power amplifier. Unless an external
power amplifier is used, the jumper pins should
remain connected to the
Preamp Out
jacks
›
.
›
Pre-Out/Main-In Jumper Pins:
These pins connect the receiver’s preamp and
amplifier sections. Unless an external amplifier,
equalizer or speaker processor is used, they should
be left connected. See page 12 for more informa-
tion on external amplifier connections.
fi
Preamp Out:
These jacks provide an
output for the left and right channels to an
optional external amplifier. In normal opera-
tion, unless an external power amplifier is
used, the jumper pins should remain connected
to the
Main In jacks
‹
.
fl
Subwoofer Out:
Connect these jacks to
the line level input of a powered subwoofer. If
an external subwoofer amplifier is used, connect
this jack to the subwoofer amplifier input. When
a single, mono subwoofer is used, make the
connection to the bottom jack.
‡
Speaker 1 Terminals: Connect these
terminals to the appropriate terminals on your
speakers.
°
Speaker 2 Terminals:
Connect these
terminals to the appropriate terminals on your
speakers.
·
Accessory Outlets:
These outlets may
be used to power low-current draw devices
such as CD players or cassette decks. The power
to these outlets remains on as long as the
receiver itself is on. When the receiver is turned
off, or placed in the Standby mode, power to
these outlets is removed.
NOTE: The power consumption of the devices
plugged into these outlets should not exceed
100 watts.
a
Power Cable: Connect the AC plug to a
nonswitched AC wall output.