Harman Kardon AVR 140, Руководство по обслуживанию

Страница: 105 / 160

Digital-audio frame clock input. FLRCLKN1 typically is run at the sampling frequency.
FLRCLKN1 operates asynchronously from all other DSPAB clocks. The polarity of FLRCLKN1
for a particular subframe can be programmed by the DSP.
BIDIRECTIONAL - Default: INPUT
FSDATAN1 — PCM Audio Data Input One
Digital-audio data input that can accept from one compressed line or 2 channels of PCM data.
FSDATAN1 can be sampled with either edge of FSCLKN1, depending on how FSCLKN1 has
been configured.
INPUT
CMPCLK, FSCLKN2 — PCM Audio Input Bit Clock
Digital-audio bit clock input. FSCLKN2 operates asynchronously from all other DSPAB clocks.
The active edge of FSCLKN2 can be programmed by the DSP.
BIDIRECTIONAL - Default: INPUT
CMPDAT, FSDATAN2 — PCM Audio Data Input Number Two
Digital-audio data input that can accept either one compressed line or 2 channels of PCM
data. FSDATAN2 can be sampled with either edge of FSCLKN2, depending on how FSCLKN2
has been configured.
BIDIRECTIONAL - Default: INPUT
FDBCK — Reserved
This pin is reserved and should be pulled up with an external 3.3k resistor. INPUT
FDBDA — Reserved
This pin is reserved and should be pulled up with an external 3.3k resistor.
BIDIRECTIONAL - Default: INPUT
PLLVDD — PLL Supply Voltage
2.5 V PLL supply.
PLLVSS — PLL Ground Voltage
PLL ground.
RESET — Master Reset Input
Asynchronous active-low master reset input. Reset should be low at power-up to initialize the
DSP and to guarantee that the device is not active during initial power-on stabilization periods.
At the rising edge of reset the host interface mode of DSPAB is selected contingent on the
state of the FHS0, FHS1, and FHS2 pins. At the rising edge of reset the host interface mode
of DSPC is selected contingent on the state of the UHSO, UHS1, and UHS2 pins. If reset is
low all bidirectional pins are high-Z inputs.
INPUT
TEST — Reserved
AVR140 harman/kardon
105