Terminating to Deadend Post
5. Open sideplates without
pulling line through block.
Terminating to deadend post lets you attach block to a closed bail such
as a padeye.
1. Remove screw.
3. Insert loop into block
mouth as shown.
4. Pass loop ends through
mouth so loops extend
beyond block's sideplates
as shown.
2. Remove deadend post.
6. Part legs of loop and
insert deadend post.
Make sure deadend
post is seated straight
in sideplate. Put
sideplates together.
7. Pull loops to seat ends
on deadend post.
8. Reassemble block using
blue Loctite
®
adhesive
on screw.
Loop
Deadend post
Deadend post
WARNING! Webbing or smaller lashings can be damaged by
being pinched between post and sideplate. Damaged webbing
or lashings can part suddenly under load. Use only loops when
terminating at deadend post.
Tip: With shorter loops, place loop at the side of the head to allow more
room to insert the deadend post.
Loctite is a registered trademark
of Henkel AG & Company KGaA.