Hardy H25, Инструкция по установке и эксплуатации

Страница: 15 / 42

HARDY MANUFACTURING CO., INC (MODEL H25) PAGE 5
Section II 2-2 Hull Removal
After placing your new Hardy Heater upon the concrete pad, you are ready to
continue the installation process. There are two methods to gain access to the rear
of the
heater to make plumbing and electrical connections.
The first and easiest method is to remove the screw holding the back door panel in
place. The door is easily removed by lifting up on the handle and taking it out.
With the back door removed, using a 5/16” wrench, remove the 8 metal screws that
are located below the back door. There are four on each side that hold the panel in
place. After the screws are removed, the panel should come out easily and allow
access to the bottom of the unit to make plumbing and electrical connections.
The second method is the removal of the entire cover. With the back and the
rectangular piece of stainless and insulation between the fire box and ash door
removed, the outside cover can be lifted up and off as seen in the picture. To
replace the cover simply repeat these steps in reverse order.
REAR FRONT