Hardt INFERNO 3500, Руководство по эксплуатации

Страница: 12 / 18

Page 12 of 18
C
U
S
-0
1
3
-0
0
2
7
-0
2
5.3 Loading & Unloading the Rotisserie
CROSS CONTAMINATION OF RAW ONTO COOKED PRODUCT IS VERY
DANGEROUS.
DO NOT LOAD UNCOOKED PRODUCT INTO ROTISSERIE UNTIL COOKING
CYCLE IS COMPLETE AND ALL COOKED PRODUCT IS REMOVED FROM
ROTISSERIE.
5.3.1 Loading the Skewers
When the rotisserie reaches operating temperature skewers can be loaded.
Open the door to shut off burner and to stop the drive rotation. Use the green Manual Advance Switch (as indicated in
Figure 4-4 on page 9) to position sockets as required.
The orientation of the skewer in the socket will vary depending on the model of
your equipment.
Follow these steps to properly load skewers into the rotisserie.
1. As indicated in diagram ‘A’ below, insert pointed end of the skewer into a hole in the plate on left side of
rotisserie.
2. Align the other end of the skewer with the corresponding socket and push into place (see diagram ‘B’).
3. Slide the skewer back to the left until the shoulder of the tip at the left end of the skewer rests against the left
end plate.
4. Check that the skewer is secured in position (holds in place).
5. Advance the drive to another position using the green manual advance switch. Repeat steps 1-5 as required.
6. Close the door, select the proper cooking program, and the rotisserie will begin to cook.
USE PROTECTIVE CLOTHING WHEN LOADING AND UNLOADING THE
ROTISSERIE.
5.3.2 Unloading the Skewers
1. Open the door to shut off burner and to stop the drive from rotating.
2. Remove each skewer by lifting left end, sliding the skewer to the left and then gently pivot the skewer out of
the rotisserie. Place each skewer on a skewer cart or a cooked food table.
3. Use the green manual advance switch to position skewers (or baskets) as required for removal.
4. Close the door of the rotisserie to resume operation or cooking (burner will reignite).
5. If no further cooking is required, press and hold the “STOP” button for three seconds to end the program.
Figure 5-2: Loading Skewers
A) B)
Slide skewer into the
support plate
Push skewer into socket in
the drive plate.
Align skewer
with socket
Shoulder