If either of the stopwatch hands are not in the "0" position , reset them following the procedure below.
1) Pull the crown out to :
VD50, VD51, VD52, VD53, VD57 (calibres with date window) : second click
VD54, VD55, VD56, VD59 (calibres without date window) :
fi
rst click
2) Press button A or B to reset all stopwatch hands to "0" position.
* The stopwatch minute hand moves correspondingly with the stopwatch second hand.
* The hands move quickly if the respective buttons are kept pressed.
3) Push the crown back to the normal position.
* Before setting the time, check that the chronograph measurement is stopped.
VD50, VD51, VD52, VD53, VD57 (calibres with date window) :
1) Pull out the crown to the
fi
rst click.
2) Turn the crown clockwise until the preview day's date appears.
3) Pull out the crown to the second click when the second hand
is at the 12 o'clock position. It will stop on the spot. Set the
hands to the desired time of the day (make sure AM/PM is set
correctly) by turning the crown.
* When the crown is at the second click position, do not press any button. Otherwise the chronograph hands
will move.
4) Push the crown back in the normal position in accordance with a time signal.
* Do not set the date between 9:00 P.M. and 1:00 A.M, otherwise the day may not change properly. If it is
necessary to set the date during the time period,
fi
rstly change the time to any time outside it, set the date and
then reset the correct time.
TIME SETTING
Button A
Button B
set the day set the time
* Before setting the time, check if all the chronograph hands - 1/10 second (where applicable), second, minute -
are at the "0"(12 o'clock) position.
* If the stopwatch is in use, press the buttons in the following order to reset it, and then, check if the hands return
to "0" position. (For details , see "HOW TO USE THE STOPWATCH")
* If the chronograph is counting :
A -> B
* If the stopwatch is stopped :
B
* If the split time is displayed :
B -> A -> B
ADJUSTING THE STOPWATCH HAND POSITION
www.hardingwatches.com
