Hardi Ranger Series, Инструкция

Страница: 66 / 88

6 - Ma int e n a nc e
6.14
WARNING! The rear cable can snap and injure you or some-
one else if tensioned when the boom is unfolded. Always
adjust the front cable first - with the boom unfolded and the
rear cable last - with the boom folded in transport position.
1. Raise boom to its highest position. Fold it to transport position
with tilt cylinders fully extended. Make sure that fold cylinders are
pressurized and that the boom is folded all the way in.
2. Ensure the boom transport brackets are in contact with the outer
wing. Adjust if necessary.
3. Loosen the jam nuts (E) on the ends of turnbuckle (F). Adjust the
turnbuckle (F) so that the outer section contacts the boom transport
bracket.
Turn the turnbuckle another 4 complete turns.
4. Secure jam nuts (E) again.
A dj ustin g r ea r c a b le
ATTENTION! Adjust both boom wings in one sequence.
Adjust one cable a small amount at the time, and then the
other cable, to equalize cable tension and maintain a level
center frame.
WARNING! Never adjust the center cables without having
folded the boom all the way into the transport position.
The center section cables keep the center frame in correct position
during folding procedure or when spraying with one side raised and
folded (SPB-HZ only).
1. Fold the boom into transport position.
2. Check that the tilt cylinders are completely extended. Adjust if
necessary (SPB-HZ only).
3. Check that center section cable (A) is routed over center section
nozzle bracket (B).
4. Loosen jam nuts on the bolt assembly (C). This applies both boom
wings.
5. Adjust the threaded bolt(s) (C). Alternate from side-to-side while
making adjustments. As a guideline for adjustment, the distance (D)
shown at the bolt assembly should be 4-5/16” (110 mm). Properly
adjusted cables will be very tight and only deflect a small amount
(fractions of an inch) when pulled by hand. Note that cables will be
loose when the boom is unfolded.
6. Tighten jam nuts on the bolt assembly (C) again.
7. Unfold the boom and inspect that the center frame is correctly
centered.
A dj ustin g c e nt e r s e ction c a b le s