Hardi RANGER 2000, Инструкция

Страница: 62 / 82

6 - Maintenance
6.16
Change of bulbs
1 . Switch off the light.
2. Loosen the screws on the lamp and remove the cover or lens.
3. Remove the bulb.
4. Fit a new bulb, refit the cover and tighten the screws.
˜
ATTENTION! If halogen bulbs are used, never touch the bulb with the fingers. Natural moisture in the skin will cause
the bulb to burn out when the light is switched on. Always use a clean cloth or tissue when handling halogen bulbs.
Shield replacement on transmission shaft
1 . Remove bolt (A), lock (B) and grease nipple (C). Twist uni CV-joint
cover 1/4 turn and pull it backwards.
2. Remove the synthetic bearings and protection tube.
3. Remove inner bush from protection tube.
4. Assemble again in reverse order, using new parts where necessary.
Remember to fit chains again.
5 . Grease bearings.
6. Repeat procedure to the opposite part of the transmission shaft.
˜
ATTENTION! Only use genuine HARDI® spare parts to service the
transmission shaft.
Replacement of transmission shaft cross journals.
1 . Remove protection guard as described previously.
2. Remove Seeger circlip rings.
3. Press the cross journal sidewards - use hammer and mandrel if
necessary.
4. Remove needle bearing cups and cross journal can now be
removed.
5 . Carefully remove needle bearing cups from new cross journal and
install it in reverse order. Before fitting the needle bearing cups
again, check that needles is placed correctly. Avoid dust and dirt in
the new bearings.
6. Repeat procedure to the opposite part of the transmission shaft.