6
020-056-UK
HARDI HC5500 w/ JobCom
SYSTEM CHECK
Please refer to the MATRIX Quick Guide and the Hardi HC5500 user manual.
To check the system it's necessary to have full GPS signal so the vehicle must be placed
outside.
Connect all cables before starting the MATRIX and the HARDI HC5500 controller.
MATRIX
• Encode number of sections and working width.
• Encode antenna 'Direction', 'Offset' and 'Hight'
• Encode 'Overlap'
• Encode 'Delay-start' and 'Delay-stop'
• Select AUTO in the 'Work-screen' (Press the green triangle)
HARDI HC5500
• For general setup, refer to the HARDI manual
• In the 'Data exchange' menu Set COM-2 to 'VRA/Remote Control' and
baud rate = 9600.
• Turn the master switch and the section switch's ON.
• Drive forward (Min. 1.5 kmh), check that all section valves open.
• Check that all sections shows 'ON' in the Matrix display.
• Check that all sections shows 'ON' in manual mode (Red triangle).
