Hardi AutoHeight, Инструкция

Страница: 47 / 62

47
6 - Maintenance
Service info
General info
The AutoHeight system requires very little maintenance. However, some minor procedures will help ensure that your
system operates properly for many years.
Before each day of operation
Check the following:
•
Peak performance requires low friction on the boom slant mechanism. Used to hold the boom stable, friction pads are
often prone to high amounts of friction when dry. Grease as necessary. This is especially important on systems
equipped with Active Roll control.
•
Ensure breakaway brackets are well lubricated and function properly.
•
Clear any obstructions between the sensor and the ground. Any object within an 18 cm diameter circle directly below
the sensor could cause improper height readings. Check to ensure hydraulic hoses, sensor cables, or debris are clear
of the sensor.
•
Inspect the foam shield insert in each sensor. HARDI recommends to fit clean foam shields before spraying.
Sensor preparation and maintenance
Fitted into the bottom of the sensor is a foam shield (Figure 9) that can
become clogged with dust and dirt. Remove the foam from the sensor,
blow it out with an air compressor, if available, and reinsert.
μ
ATTENTION! HARDI recommends to clean the foam shield in mild
soap water and allow it to dry before reuse.
μ
ATTENTION! Bring extra clean protective shields in the tractor
cabin while spraying, for easy replacement in the field if a shield
gets dirty.
μ
ATTENTION! Do not blow out the foam shield while it is still
installed in the sensor. Sensor damage may result. Always
remove the foam shield for cleaning.
μ
ATTENTION! Do NOT spray without the foam shields installed - chemicals will damage the transducer surface!
Figure 9 - Protective Foam Shield