Hard Head 019660, Руководство по эксплуатации

Страница: 14 / 27

EN
14
NOTE:
The pressure relief valve releases steam
when the pressure in the tank increases
too much, for example if the steam hose
gets clenched. Repair and maintenance of
the valve must only be carried out by an
authorised service centre.
SYMBOLS
Read the instructions.
Warning! Hot surface!
Warning!
PLACE BOILER ON A FLAT LEVEL
SURFACE. NEVER GO UNDER
THE MINIMUM WATER LEVEL. IF
THE UNIT IS TIPPED ON ITS SIDE,
RETURN IT BACK ONTO ITS FEET
IMMEDIATELY.
Warning! Hot steam!
Wear safety gloves.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage 230 V ~ 50 Hz
Output 2000 W
Tank volume
4 litres
Hose length 3.5 m
DESCRIPTION
1. Filler cap with pressure relief valve
2. Water tank
3. Steam plate
FIG. 1
USE
1. Screw the hose on the steam plate and
water tank cap.
2. Unscrew the cap and fill the tank with
cold water, or hot water if you want to
reduce the start time. Do not fill the
tank over the MAX level.
3. Plug the plug into the power point and
wait until the water gets hot. The time
it takes to produce steam depends on
the amount of water in the tank. With
a full tank (4.5 litres) it takes 10-13
minutes.
4. Start working when steam flows out
from the steam plate.
5. Hold the steam plate against the wall
and allow the steam to work for about
10–20 seconds.
6. Cut the wallpaper (if thick) to allow the
steam to penetrate.
7. Move the steam plate and pull off the
loose wallpaper. Repeat this procedure
if the wallpaper does not come loose.
WARNING!
• Risk of scalding!
• After filling, wait for at least 15 minutes
before starting the product. (This is in
order to allow the safety switch to
reset).
• Wait five minutes before filling with
water after switching off.
• Place the product on a flat, stable
surface.