Page 3
For technical questions, please call 1-888-866-5797.
Item 63655
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this document including all text under subheadings therein
before set up or use of this product.
1. Make sure upper and lower
Outside Diameter Jaw (2) faces
are clean. See
Figure A
.
2. Loosen Slide Scale Lock (6) by turning it
counterclockwise.
3. Use Thumb Roll (1) to close
Outside Diameter Jaws (2).
4.
Sliding Index Edge (7) should line up at “0”.
5. To adjust (if needed), loosen
the Dial Adjustment Lock (3) by
turning it counterclockwise.
6. Set the Dial (5) by turning the Dial
Adjustment (4) either clockwise
or counterclockwise until the
Dial Needle points to “0”.
7. Lock the Dial (5) on its “0” setting by
tightening the Dial Adjustment Lock (3)
clockwise. The Caliper is ready to use.
2
6
1
7
3
5
4
Figure A
8. To read the Scale and Dial, the
Sliding Index Edge features readings
in tenths of inches (0.1″ per call-out
segment) and fractions (1/8″ per
call-out segment). See
Figure B
.
Sliding
Index Edge
Dial
Figure B
9. Read the Scale Measurement Point
in inches and tenths of inches (such
as 0.5″) or fractions (such as 1/2″).
10. Read the Dial Needle on the Dial
to get a more precise reading,
down to 0.01″ or 1/64″.