Page 4
For technical questions, please call 1-888-866-5797.
Item 56617
Sa
FE
ty
Op
Era
tIO
n
Ma
Int
Enanc
E
SE
tup
Operating Instructions
read the EntIrE IMpOrtant SaFEty InFOrMatIOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
attaching the Handle
cautIOn! the Handle socket may be held
down by a clip under tension. Wear anSI-
approved safety goggles before freeing
Handle socket. remove clip carefully.
1. Align the hole on the Lower Handle with
the Handle Lock Button and connect
the Upper and Lower Handles together.
Make sure the Button clicks into place.
2. Loosen the Set Screw and insert the
assembled Handle into the Handle Socket.
3. Tighten the Set Screw.
Bleeding
1. Turn handle counterclockwise
to open Release Valve.
2. Remove four screws holding on pump cover.
3. Remove Oil Fill Plug and top off hydraulic oil.
4. Apply pressure to saddle and quickly
pump handle several times.
5. Check Oil Fill Hole again and top off
with hydraulic oil if necessary.
6. Replace the Oil Fill Plug and turn handle
clockwise to close Release Valve.
7. Test several times for proper operation
before attempting to lift a load.
adding Oil
1. Remove the Fill Screw.
2. Add high grade hydraulic fluid into the Fill Screw
slowly until the oil reaches the top of the oil fill hole.
Note: Do not touch the Handle when
adding the hydraulic oil.
3. Replace the Fill Screw.
