SKU 44983
For technical questions please call 1-800-444-3353. Page 3
9.
Use the right Vise for the job. There are certain applications for which this Vise was
designed. Do not modify this Vise and do not use this Vise for a purpose for which it
was not intended.
10. If struck by a striking tool, the jaws may chip, this will damage the vise and possibly
result in eye or bodily injury. Always check the Vise for damage before using it. Always
replace the jaws if they are damaged.
11. Do not use the Vise if under the influence of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgement or reflexes are impaired while taking drugs. If there
is any doubt, do not assemble or use the Vise.
WARNING:
The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Assembly/ Operation
Your Vise comes fully assembled other than putting on the handle (10). It is important that you read
the entire manual to become familiar with the product BEFORE you use the Vise. Before ataching
the handle (10) to the Vise be sure that you have all parts described in the Parts List and Assembly
Diagram located on the last pages of this manual.
NOTE: Make certain to follow all precautions and safety warnings listed in this manual and in the
drilling or milling machine manual.
NOTE: The Vise weighs 72 Lbs. It is recommended that two adults are present when moving or
assembling the Vise. Before intial use of the Machine Vise, use a soft cloth to wipe off the protective
coat of grease.
1.
To mount the Machine Vise to your milling or drill table Insert the T-Slot Bolts (15) into the
T-Slots on the Vise as shown in Figure 1.
T-Slot Bolt (15)
Figure 1
2. Set the Machine Vise so that the T-Slot Bolts (15) in the Machine Vise line up with
the T-slots on the drill or mill table. Make certain that the surface being used is capable of
supporting the weight of the Vise and anything clamped into the Vise. Make certain that the
Vise is stable and secure once set in place on the milling/drilling machine. Then us T-nuts
(not provided) to secure the Machine Vise to the mill or drill table.
Brought to You by Augusta Flint
