Page 6
For technical questions, please call 1-888-866-5797.
Item 58203
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Mounting the Trailer to the Towing Vehicle
1. Before mounting, chock the trailer wheels
to prevent the trailer from rolling.
2.
If using the Jack with electric power:
a. Check that the Jack has been properly
wired by testing the Directional Switch.
b. If needed, turn on the LED lights
using the Light Switch.
Note:
The LED lights will only work
when the Jack wiring is powered.
c. Check that the Switch Cover (27) is
secured over the Light Switch (3).
d. Push the Directional Switch (4) up to raise the
trailer to the level of the towing vehicle’s hitch.
Release Directional Switch to stop the Jack.
NOTICE:
Release Directional Switch when the
motor slows, or switches off, to prevent damage
to the motor. Wait 15 seconds for the motor
to reset before operating the Jack again.
3.
If using the Jack manually:
a. Disconnect power to the Jack.
b. Remove the Protective Cap (1) on the top of
the Jack to access the Drive Shaft (11).
c. Insert the Crank (17) onto the Drive Shaft.
d. Rotate the Crank counterclockwise to raise the
trailer to the level of the towing vehicle’s hitch.
Crank
Rubber
Access
Cover
4. With the assistance of a spotter,
back the vehicle to the trailer.
5. Mount the trailer onto the towing vehicle’s hitch.
6. Push the Directional Switch down toward the Jack
(electric) or turn the Crank clockwise (manual)
to retract the Jack slightly, lowering the trailer and
transferring its weight onto the towing vehicle.
7. Once trailer is fully engaged, continue to
retract Jack up to the “STOP” label on the
Inner Tube (20). Trailer Jack must always
be fully retracted when towing the trailer.
8. Attach the safety chain (sold separately).
Dismounting the Trailer from the Towing Vehicle
1. Before dismounting, chock the trailer wheels
to prevent the trailer from rolling.
2.
If using the Jack with electric power:
a. If needed, turn on the LED lights
using the Light Switch.
Note:
The LED lights will only work
when the Jack wiring is powered.
b. Check that the Switch Cover is
secured over the Light Switch.
c. Push the Directional Switch (4) up to raise the
trailer to the level of the towing vehicle’s hitch.
Release Directional Switch to stop the Jack.
3.
If using the Jack manually:
a. Disconnect power to the Jack.
b. Remove the Protective Cap (1) on the top of
the Jack to access the Drive Shaft (11).
c. Insert the Crank (17) onto the Drive Shaft.
d. Rotate the Crank counterclockwise to
extend the Jack and raise the trailer.
4. Continue to extend just enough for the Trailer
Jack to take the weight of the trailer. This will
make it easier to disengage the trailer hitch.
5. Disengage the electrical connections, the trailer
hitch, any safety chains or other connections,
between the vehicle and the trailer.
6. You may need to extend the Jack further
to clear the trailer hitch. When the vehicle
is completely clear, and it is safe to do so,
drive the vehicle away from the trailer.
CAUTION:
Have a spotter watch this operation
to be sure the trailer is clear of the vehicle.
7. When finished raising or lowering the trailer:
a. If using with electric power,
disconnect power to the Jack.
8. If using the Jack manually, remove the
Crank and replace the Protective Cap.
Store the Crank in a safe place for future use.
SAFETY
OPERA
TION
MAINTENANCE
INST
ALLA
TION
