Page 4
For technical questions, please call 1-800-444-3353.
SKU 68754
Assembly
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM BURNS:
Turn the Switches (21) of the heater off,
to
O
position, unplug the heater from
its electrical outlet, and allow it to cool
completely before assembling, moving, or
making any adjustments to the heater.
Note:
For additional information regarding
the parts listed in the following pages, refer to
Parts List and Assembly Diagram
on pages 6 and 7.
1. Install one Leg (1) on each corner of the Housing (3)
using 3 bolts and washers as shown in Figure A.
Figure A: Leg Installation
bolt &
washer
Leg
(1)
Housing (3)
2. Make sure all legs are installed securely before use.
Do not use with any legs missing,
bent, crooked or loose.
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Area Precautions
TO PREVENT SERIOUS INJURY FROM BURNS:
Turn the Switches (21) of the heater off,
to
O
position, unplug the heater from
its electrical outlet, and allow it to cool
completely before assembling, moving, or
making any adjustments to the heater.
1. Place Heater on dry, hard, stable floor away from
combustible materials.
DO NOT USE ON CARPET.
2. Supervise children closely when near heater.
3. Keep pets away from heater.
Controls
Note:
Controls are located inside the Door (2).
Use the Door Handle (5) to open the Door.
Figure B: Control Panel
Turbo
Heating
Thermostat
Flame
Intensity
Flame
Thermostat
Knob
Turbo
Switch
Heating
Switch
Flame/Power
Switch
Flame
Knob
Flame/Power Switch:
Switch to
I
position to
turn the unit on and enable the flame effect.
Flame Knob:
Adjusts the intensity of the flame effect
while the Flame/Power Switch is in the
I
position.
Does not effect the heat output.
Heating Switch:
Switch to
I
position while the Flame/
Power Switch is in the
I
position to turn on the blower
and the heating element. The heating element
will turn off once the temperature triggers
the thermostat, but the fan will continue operating.
Turbo Switch:
Switch to
I
position while both
the Flame/Power Switch and the Heating Switch are in
the
I
position to set the heating element to high heat.
Thermostat Knob:
Adjusts the temperature at which the
heating element shuts off while the Heating Switch is in
the
I
position. The fan and flame effect will continue even
if the heating element shuts off. The heating element
will restart once the temperature falls.
