Page 6
For technical questions, please call 1-888-866-5797.
Item 63320
Installation Instructions
1. Position Pump on solid surface.
WARNING! TO PREVENT SERIOUS INJURY:
This is
NOT a submersible pump. Do not immerse in water.
2. Plug Power Cord into GFCI protected outlet.
GFCI-
Protected
Receptacle
Figure A: GFCI Plug
3.
7KH3XPSXVHVƎ137SLSLQJVROGVHSDUDWHO\
Purchase the necessary length of pipe, including
any needed fittings and bends. Mount the Pump
as close to the source of water as possible
and within the range of the rated Suction Lift.
The connections must be airtight. Wrap all threaded
connections with PTFE tape (sold separately).
Inlet
Priming
Plug
Outlet
Pump Body
Power Switch
Figure B: Pump Components
4. Remove the Inlet and Outlet Covers from the Pump.
5. Attach the water source to the Inlet, using appropriate
methods. The Inlet hose or pipe must be collapse-
proof to properly withstand the suction force.
6. Install a foot valve and filter (sold separately)
at the bottom of the inlet.
Pump
Bucket
full of
clean
water
Priming Hose
Priming Hose
Outlet Pipe
Outlet Pipe
Inlet Pipe
Inlet Pipe
Foot
Foot
Valve
Valve
Y-fitting
Y-fitting
(with one valve
(with one valve
for each outlet)
for each outlet)
Figure C: Pump Position
7. Attach the outlet connection to the Outlet.
A Y-fitting with dual valves (sold separately) is
helpful for priming the pump (see Figure B).
Note:
A foot valve on the inlet connection is critical
to help prevent the pump from losing prime.
Note:
Check that the water source and piping
are clear of sand, dirt and debris.
8. Connect a bucket full of at least 3 gallons of water
to one side of the Y-fitting using a hose, as shown
above. (If available, a continuous water supply,
such as a spigot, may be used instead.) The bucket
must be positioned higher than the pump’s outlet.
9. Close the valve on the outlet side of the Y-fitting, and
open the valve on the priming side of the Y-fitting.
10. Remove the Priming Plug and wait until water
starts coming out of the Priming Plug. Replace
the Priming Plug and tighten securely.