Page 3
For technical questions, please call 1-800-444-3353.
SKU 66399
ing the tool. Do not use the tool while
tired or under the influence of drugs,
alcohol, or medication.
A moment of
inattention while operating the tool in-
creases the risk of injury to persons.
b.
Avoid unintentional starting. Be sure
the switch is off before connecting to
the air supply.
Do not carry the tool with
your finger on the switch or connect the
tool to the air supply with the switch on.
c.
Do not overreach. Keep proper foot-
ing and balance at all times.
Proper
footing and balance enables better con-
trol of the tool in unexpected situations.
d.
Always wear eye protection.
Wear ANSI-approved safety
goggles.
e.
Always wear hearing pro-
tection when using the tool.
Prolonged exposure to high
intensity noise is able to
cause hearing loss.
Tool use and care
a.
Do not force the tool.
Use the correct
tool for the application. The correct tool
will do the job better and safer at the rate
for which the tool is designed.
b.
Do not use the tool if the switch does
not turn the tool on or off.
Any tool that
cannot be controlled with the switch is
dangerous and must be repaired.
c.
Disconnect the tool from the air
source before making any adjust-
ments, changing accessories, or stor-
ing the tool.
Turn the switch to its off
position and disconnect from the battery.
d.
Store the tool when it is idle out of
reach of children and other untrained
persons.
A tool is dangerous in the
hands of untrained users.
e.
Maintain the tool with care.
f.
Check for misalignment or binding
of moving parts, breakage of parts,
air leaks, frayed wires, and any other
condition that affects the tool’s op-
eration.
If damaged, have the tool ser-
viced before using. Many accidents
are caused by poorly maintained tools.
There is a risk of bursting if the tool is
damaged.
g.
Use only accessories that are identi-
fied by the manufacturer for the spe-
cific tool model.
Use of an accessory
not intended for use with the specific
tool model, increases the risk of injury to
persons.
Service
a.
Tool service must be performed only
by qualified repair personnel.
b.
When servicing a tool, use only identi-
cal replacement parts. Use only au-
thorized parts.
c.
Use only the lubricants supplied with
the tool or specified by the manufac-
turer.
SAVE THESE
INSTRUCTIONS.
