SKU 98177
For technical questions, please call 1-800-444-3353.
Page 5
aSSemblY inStructiOnS
read the entire impOrtant
SaFetY inFOrmatiOn section at the
beginning of this document including
all text under subheadings therein
before set up or use of this product.
assembly
battery installation:
Use a Phillips head (Cross-Head) screw-
1.
driver to loosen screw on the transmitter’s
battery cover by turning the screw in a
counter-clockwise direction. (See Fig.1.)
The screw has a fiber retaining washer on it
2.
so that it does not fall out of the hole in the
battery compartment cover. But loosening
this screw allows the cover to be removed for
battery insertion.
Insert 6 “AA” 1.5V size batteries in the bat-
3.
tery compartment according to the marked
polarity directions shown inside the compart-
ment. (See Fig. 2.)
The batteries of choice would be new alka-
4.
line batteries.
Replace the cover and tighten the screw in a
5.
counter-clockwise direction. (See Fig.3.)
You can use either rechargeable or non-
6.
rechargeable batteries in transmitter.
Do not mix different types of batteries and do
7.
not mix new and used batteries.
Non-rechargeable batteries are not to be
8.
recharged.
Rechargeable batteries are to be removed
9.
from the transmitter and recharged in their
own battery charger.
Rechargeable batteries are only to be
10.
charged by a responsible adult.
Only batteries of the same or equivalent type
11.
as recommended, are to be used at any one
time.
Batteries are to be inserted properly accord-
12.
ing to polarity instructions.
Fig. 1
Fig 2
Fig 3
transmitter layout
