Page 5
SKU 95907
for technical questions, please call 1-800-444-3353.
replacing the fan blade
warning!
Make sure the Speed Control Switch is in its “OFF” position and that
the Car Fan is unplugged from its power source before performing any inspection,
maintenance, or cleaning procedures.
Pull off the Rubber Ring (12) separating the Rear Steel Grill (9) and Front Steel Grill
(13). Pull off the Front Steel Grill (13).
Pull the Fan Blade (11) straight out to remove it. Press the new Fan Blade (11)
back into place. Replace the Front Steel Grill (13) and slide the Rubber Ring (12)
back into place.
Mounting the speed control switch
The Car Fan Speed Control Switch (2) can be mounted to the vehicle as desired
(hardware not included).
Make certain that all drilling paths are clear of electrical lines, cables, wire and any
other obstructions.
Make certain that there is sufficient length in the Power Cord (3) to reach from the
Cigarette lighter to the location of the Speed Control Switch (2).
Use the Speed Control Switch as as template to mark two holes in the desired
surface. Drill holes in the desired surface.
Align the holes in the Speed Control Switch (2) with the drilled holes. Mount the
Speed Control Switch (2) using hardware (not included) of a sufficient length and
strength. The screws used must be able to fully secure the Speed Control Switch
in place.
1.
2.
3.
1.
2.
3.
4.
5.
