SKU 95706
For technical questions please call 1-800-444-3353
Page 6
Operation (Continued)
Normal Operation:
1.
The Power Switch is on the underside of the Lantern Cover. After initially
charging the batteries, move the Power Switch to the ON position. When in
the ON position, the Lantern will come on whenever the Photo Eye detects
that the light level is low.
2.
To turn the Lantern OFF, move the Power Switch to the OFF position.
Maintenance
1.
Protect this device from damage or excess exposure to rain, sun and wind.
2.
Occasionally clean the solar panel surfaces, Lantern Glass and Photo Eye
with a clean soft cloth. Do not use detergents or solvents for cleaning.
3.
Occasionally check the installation to be sure the Lantern is secure.
If the Lantern will not recharge or light normally:
1.
First check to see if it is getting enough sunlight during the day.
2.
Check to see that the Solar Panels are clean.
3.
Test the voltage output of the batteries. If the solar panels are functioning
properly, and the batteries are not storing energy, they must be replaced.
Changing the Batteries:
1.
Slide the power switch to the “OFF” position.
2.
Remove the (4) Screws from the underside of the Lantern Cover (A). Set them
aside for safekeeping.
3.
Rotate Plastic Reflector so that it release from ledges and set it aside.
4.
Press release tabs. Pull and remove battery covers.
5.
Replace the batteries with identical replacements, being careful to match the
polarity of the batteries. Always properly dispose of all used batteries.
6.
Replace the battery covers and PLastic Reflector.
7.
Replace the Lantern Cover (A) and secure it in place using the (4) Screws.
8.
Slide the power switch to the “ON” position.
NOTE: It is recommended that the batteries be charged for at least 8 hours of
daylight with the Power Switch in the OFF position before first use.
CAUTION: This Lantern is intended for decorative use only. Do not use this lantern
for any safety-related illumination task.
Troubleshooting
