SKU 95621
Page 5
Extendable
Arm (5)
Roller
Head (4)
Adjusting
Handle (3)
5. Slide a Small Screw (7) through a Small Washer (9) and use them to fasten
the Roller Head (4) to the top of the Extendable Arm. Tighten with a Small
Nut. (11). Make sure the Screw fits all the way through the Arm and that the
Roller Head (4) is fastened tight. See Figure 2.
Operation
1. Before use, be sure the Roller Stand is situated on a flat, level surface,
capable of supporting the weight of the Stand plus the weight of your work
piece.
2. You can adjust the height of your Roller Stand from 26-3/4” to 42-3/4” H.
To do so, loosen the Adjusting Handle (3) by turning it. Raise or lower the
Extension Arm (5) to the desired height.
3. Tighten the Adjustable Handle (3) again.
Please note: Be sure the Handle is
fully tightened before using the Stand.
4. Place the Roller Stand in the desired location in the work area. Make sure
the Stand is set at the appropriate height for the task at hand. Also, always
ensure that the workpiece supported by the Stand is stable and level.
Maintenance
1. Periodically check Roller Head (4) and all hardware for tightness.
2. Periodically clean the Roller Stand with warm water and a soft cloth.
Figure 2
Small
Screw (7)
and Small
Washer (9)
