SKU 91194
PAGE 3
3.
Use the right product for the job. There are certain applications for which this
product was designed. Do not modify this product, and do not use this product for
a purpose for which it was not intended.
4.
Maintain labels and nameplates on this product. These carry important infor-
mation. If unreadable or missing, contact Harbor Freight Tools for a replacement.
5.
Do not use this product in excessive heat and humidity conditions.
6.
Do not allow children to handle this product. This product is constructed with
small parts that may pose a serious choking hazard if swallowed.
7.
WARNING! The warnings, precautions, and instructions discussed in this manual
cannot cover all possible conditions and situations that may occur. The operator
must understand that common sense and caution are factors, which cannot be built
into this product, but must be supplied by the operator.
OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages refer to
Figure A, below.
POWER SWITCH (2)
LCD DISPLAY (1)
RANGE SELECTION SWITCH (3)
DATA HOLD SWITCH (4)
PHOTO DETECTOR (5)
FIGURE A
1.
Press the Power Switch (2) to turn the Light Meter “ON”. Press the Power Switch
again to turn the Light Meter “OFF”. (See Figure A.)
2.
Press the Range Selection Switch (3) to select between the ranges of 1 ~ 2,000/
20,000/50,000(200,000) Lux. At the same time, the LCD Display (1) will indicate
the value by which to multiply to receive the correct value. (See Figure A.)
