Page 10
For technical questions, please call 1-888-866-5797.
Item 57293
Inspection and Maintenance
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ELECTRICAL SHOCK:
Make sure that the Helicopter is OFF before performing any procedure in this section.
Inspection
1.
BEFORE EACH USE,
inspect
the general condition of the
Helicopter. Check for:
• stripped gears,
• bent main shaft,
• cracked or broken rotors, and
• any other condition that may
affect its safe operation.
Cleaning and Storage
1.
AFTER USE,
use a mild detergent
on a clean cloth to remove any
dirt from the Helicopter.
2. Remove batteries from Remote
Control, then store the Helicopter,
and accessories in a dry area
away from direct sunlight and
out of the reach of children.
3. Li-Ion BATTERY MUST BE RECYCLED
OR DISPOSED OF PROPERLY.
Do not short, incinerate or open battery.
Replacing Rotors
Main
1. Remove Screw holding the Rotor in place.
2. Gently lift up Tab holding Rotor onto Shaft. Lift Rotor off Shaft and remove. See below.
Hole
Tab
Shaft
Rotor
Side View
3. Replace Rotor and Screw,
tighten screws enough so that
Rotor can move freely.
Note;
The replacement Upper Rotor
is marked as ‘A1.’ The replacement
Lower Rotor is marked as ‘B2.’
