7
ASSEMBLY INSTRUCTIONS
4. Loosen but do not remove the two set screws (I)
in the yoke of the motor assembly (H). Slide the
downrod tube into the yoke of the motor assembly
(H), align the holes, then install the downrod pin and
downrod clip from downrod pack (E). Retighten the
two set screws (I) to secure the downrod. Then slide
the yoke cover (F) down until it rests on top of the
motor assembly (H).
5. Note: Parts mentioned in this step are found in
downrod pack (E).
Lower the downrod ball over downrod tube. Then
insert steel pin through the two holes in downrod
tube. Align the steel pin with the two notches in the
downrod ball. Then lift downrod ball all the way up
until it is level with the top of downrod tube.
Insert and tighten the two downrod set screws into
the two small holes near the top of downrod tube.
Note:
Two slots in downrod ball allow access for the
downrod set screws.
6. Insert downrod ball from downrod pack (E) into the
opening of the mounting bracket (A). Rotate the
downrod ball until the tab in the mounting bracket (A)
is seated in the slot in the downrod ball.
WARNING:
The fan and/or downrod ball should
not rotate in the mounting bracket (A), if installed
correctly. Failure to align the slot in the downrod ball
with the tab on the mounting bracket (A) may result in
fan falling causing serious injury or death.
5
4
H
I
D
F
Downrod
Set Screw
Downrod
Ball
Downrod
Ball
Downrod
Tube
Downrod
Pin
Downrod
Clip
Slot
Notch
Steel Pin
Overhead View
6
A
Slot
Tab
